Draw

Brush Tool: 

            Draw:  

           This is the default drawing tool. It lifts the digital clay up from the surface of the model (or pushes it in if Invert is active). If a stroke crosses the same area multiple times, each time will build the surface up higher.

The draw brush smoothly sculpts the mesh. Its strength is given by the Intensity parameter. Activating the Invert checkbox inverts the sculpting direction, so that the brush creates a hollow at the cursor position. Activating the Flat checkbox results in a more leveled deformation. and prevent deformations to add up when dragging over the same spot multiple times in a single stroke. Short Cut of Draw: D

        Pressing the Alt key causes the draw brush to carve into, rather than build up the model.