Message

Message： Hello, I would like to ask, if there is a translation of UCANCAM V11 into Polish language? Roman 2021/03/08

Reply： yes, you can contact with digima company in polish ( 2021/03/08 )

Message： Hello. Does ucancam has stats like Enroute? I mean to see how long will it take before starting to cut. Pedro 2021/03/01

Reply： yes, there is stats in ucancam. ( 2021/03/01 )

Message： Hello. To work on a CNC machine, I need the program Ucancam Pro version 11.5. I can download this program from your website, and where can I buy a key for this program? Dmitriy 2021/02/25

Reply： you can buy from http://www.ucancam.com/purchasing.asp ( 2021/02/25 )

Message： Hello, I need Ucancam V10.7 software installatioon file. I have dongle but not have setup file. Please help. Thanks. Tanzer 2021/02/19

Reply： you can download http://www.ucancam.com/V11.4-Ucancam-Eng.rar to try ( 2021/02/19 )

Message： Hi I am strugling to cut my files , the size is way below maximum table size but it still errors on y+ over soft limit. checked work bound and this size is about 2 x drawing size. please help Remondo 2021/02/19

Reply： pls check the origin point when you export nc code.make sure it is not far away the part. ( 2021/02/19 )

Message： Getting a message “failed to create empty document” on start up Verdun 2021/02/19

Reply： your dongle is not matched with ucancam version. ( 2021/02/19 )

Message： How i can modify “tool change” command in post processor file so that the spindle turns ? the programme running but the spindle is power OFF . i try all processor file and i modify but not turn the spindle. and i can install UcanCam V9 waves in Win 10 ? you have update driver of dongle ? helaoui 2021/02/19

Reply： pls check if you add “M03 ” in “tool change” command. ( 2021/02/19 )

Message： hi..im having a problem…when saving the file it is showing different value eg im using a bit which i assign to cut a depth of -4mm when i save the file the depth would have changed to -8mm.please help musa 2021/02/19

Reply： pls check the z of origin point when you export nc code. ( 2021/02/19 )

Message： существует версия ucancam v8 на русском языке или только на английском? Илья 2021/02/19

Reply： ucancam V8 is too old. it is out of service now ( 2021/02/19 )

Message： Hello Seems to a problem when i eksoport data to NC studio program. Its out of limit even everything is on 0 all akses. Had this problem before and then i had to instal the program again. is it possible to just run an download from the website instead of delete an new instale? Harald 2021/02/19

Reply： about the limit problem. it is not related with version. you need check the origin point you set in export nc code. ( 2021/02/19 )

GuestBook

Cancel reply